Black Box Wizard DVI SRX Guia do Utilizador descarregar pdf (Página 5)



F









BLACK

BOX

REM

LIN

POW

724-746-5500

Installation

Connections

Installation of the DVI SRX modules is straightforward and requires minimal

conﬁguration in most cases.

• Connections at the local module

• Connections at the remote module

Note: After all connections are made, power up the remote module ﬁrst and

then switch on the computer.

INSTALLATION ADVICE – Connect the supplied protective ferrites at each

end of the CATx link cable and avoid disconnecting the CATx link cable

whilst the product is operational (powered on).

Switch settings

Both modules have a block of four mini switches located on their side panels. All

switches should remain OFF at all times during normal operation. Switch 1 on

the remote module is used to place both modules into upgrade mode. All other

switches are not used and should remain OFF at all times.

Mounting the modules – desk or rack

The DVI SRX modules can be situated on a desk (or ﬂoor) or alternatively, for

larger installations, mounted within an optional rack mount chassis.

Desk mount

Apply the supplied self-

adhesive rubber feet to the

underside of the module.

Rack mount

Note: The module switches are not accessible once it is inserted into the rack,

therefore, check all settings before insertion.

1 Place the rack securing plate (available as a separate kit) onto the front of the

module and secure it with the two countersunk screws.

2 Orient the DVI SRX module on its side so that its labelled face is the correct

way up.

3 Slide the module into the required rack position. The rectangular cut-out in

the front upper lip of the rack allows the two screws on the module’s upper

edge to slide through.

4 The rack mount chassis has a series of holes in its ﬂoor that are spaced to

accommodate the two screws on the module’s lower edge. Ensure

that the screws correctly locate into the two holes of the

chosen slot. The rack securing plate on the module should

now be ﬂush with the front of the rack mount

chassis.

5 Use the third (pan-head) screw, in the

top hole of

the rack

securing

plate to

fasten the

module to the

rack.

1 2 3 4 5 6 7 8 9 10 ... 16 17

Comentários a estes Manuais

Sem comentários

Black Box Wizard DVI SRX Guia do Utilizador Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Interruptores KVM Black Box Wizard DVI SRX