SERVVIEW II / III AND SERVVIEW II ULTRA
2
At the time of this writing, your complete ServView II / III or ServView II Ultra package should include:
• The main tray assembly as ordered.
• A User Cable for connecting to one of the ServSwitch user ports. (Models that include a ServSwitch only.)
• An AC power-input cord for the ServView II’s TFT. All models that have integrated ServSwitches will also
include an AC power input cord for the switch.
• For the ServView II / III models that have integrated ServSwitches, a hardcopy manual for that type of
ServSwitch. (Only the specifications, descriptions, and instructions for the ServView product code listed
for your ServView II model on the front of this sheet will apply.)
• Ten 10/32” rackmounting screws and cage nuts. (Eight are required for assembly, two are extra.)
NOTE
The components that come with your ServView II / II might vary and are subject to
change without notice.
SERVVIEW II / III AND SERVVIEW II ULTRA
3
To mount the ServView II / III or ServView II Ultra in a 19” rack, take these steps:
1. Mount your CPU(s) in the rack, where your ServView II will be installed.
2. Remove the backing plate that’s attached to the rear of the ServView II by a pair of screws.
3. Unscrew the retention screws that hold the KVM tray shut against the front of the ServView II.
CAUTION
We recommend that two people work together to perform step 4.
4. Tilt the ServView II far enough sideways to get past the Cabinet’s rails, then maneuver it through
the Cabinet until its front and rear “mounting ears” are even with the Cabinet’s front and rear rails.
Straighten the ServView II back to level so that its front ears are flush against the front of the
Cabinet’s front rails and its rear ears are flush against the back of the Cabinet’s rear rails. Align the
upper and lower holes in the mounting ears (two in each ear – eight all together – not including the
middle hole in the front ears that’s designed for the retention screws) with an appropriate set of
holes in the Cabinet’s rails, then secure the ServView II to the rails using the included screws.
5. Locate the keyboard, mouse, and video cables that come out of the back of the ServView II tray.
Attach the connectors of these cables to the matching connectors on your computer CPU or (if your
ServView II includes an integrated ServSwitch) on the included User Cable that you’ll then plug into one
of the ServSwitch’s user ports.
6. Models with an integrated ServSwitch only: Plug the User Cable into one of the ServSwitch’s user
ports. Follow the directions in the ServSwitch manual for attaching CPUs to the switch. Run the
included power cord from the ServSwitch’s power inlet to a working AC outlet.
7. Run the included power cord from the ServView II’s power inlet to a working AC outlet. Turn on
the ServView II. Refer to the manual for the ServView II’s components for information about
configuring and operating them. (Note: power must be first applied to the ServSwitch, then the CPU’s)
8. Plug in and power up the CPU(s) attached to your ServView II.
(17 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais