Black Box LB9017A-R3 Manual do Utilizador descarregar pdf (Página 11)

Express Ethernet Switch: LB9017A-R3

Optional Fiber Module Installation

Consult the following illustrations before installation.

Step 1: Make sure the power is switched off. The module is not hot-swappable.

L It may cause electric shock or any possible damage to the switch if the power is not switched off.

Step 2: Remove the module from the static-free container.

Step 3: Unscrew the cover plate of the expansion slot.

(The slot for single-port module is located at the right side of the switch.)

Step 4: Remove the plate.

(Keep it for future use if you decide to remove this module later.)

Step 5: Carefully slide the module into the slot, following the internal plastic guide rails.

Step 6: Once it is fully slid in, snap in the module to make a proper connection.

Step 7: Fasten the module screws.

Step 8: Finally, turn on the power.

Figure 4: Removal of cover plate Fiber module being installed

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sem comentários

Black Box LB9017A-R3 Manual do Utilizador Página 11