Black Box LWN600CM-1 Guia do Utilizador descarregar pdf (Página 62)

724-746-5500 | blackbox.com

Page 62

724-746-5500 | blackbox.com

Chapter 4: The SmartPath AP (LWN602A) Overview

1. Position two #6 or #8 screws 2" (5 cm) apart

and fasten them to a secure object such as a

wall, post, or beam.

2. Cut or drill a hole in the wall 1–2"

(2.5–5 cm) above the screws to pass

the cables through to the SmartPath AP.

3. Position the SmartPath AP so that the

screws enter the two upper keyhole-shaped

slots on the underside of the SmartPath AP.

Then push the SmartPath AP downward

to lock it in place.

4. Connect the cables to the SmartPath AP.

Depending on the power source, you might

connect just one Ethernet cable or an

Ethernet cable and a power cord.

SmartPath AP

(LWN602A)

Wall

Figure 4-8. Mounting the SmartPath AP on a wall.

Instead of passing the cables through a hole in the wall, you can also simply run them along the wall from the port side of the

SmartPath AP, which is located at the top of the device when it is mounted on a wall.

NOTE: You can use a Kensington lock to secure the SmartPath AP to a stationary object. For information, see “Locking the

SmartPath AP” in Section 4.5.1.

4.6 Device, Power, and Environmental Specifications

Understanding the specifications for the SmartPath AP LWN602A is necessary for optimal deployment and device operation. The

following specifications describe the physical features and hardware components, the power adapter and PoE (Power over

Ethernet) electrical requirements, and the temperature and humidity ranges in which the device can operate.

Device Specifications

• Chassis dimensions: 6.5" W x 2" H x 6.5" D (16.3 cm W x 4.6 cm H x 16.3 cm D)

• Weight: 1.75 lb. (0.8 kg)

• Antennas: SmartPath AP (LWN602A): two omnidirectional 802.11b/g/n antennas, and two omnidirectional 802.11a/n antennas

• Ethernet port: one autosensing 10/100/1000 Base-T/TX Mbps port; compliant with the IEEE 802.3af standard and the 802.at

standard for PoE (Power over Ethernet)

Power Specifications

• DC Input: 36 - 57VDC (48 V/0.3A)

• PoE input:

• 802.3af

• Pre-802.3at

• RJ-45 power input pins: Wires 4, 5, 7, 8 or 1, 2, 3, 6

Environmental Specifications

• Operating temperature: +32 to +104 degrees F (0 to +40 degrees C)

• Storage temperature: -40 to +185 degrees F (-40 to +85 degrees C)

• Relative Humidity: Maximum 95% noncondensing

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 191 192

Comentários a estes Manuais

Sem comentários

Black Box LWN600CM-1 Guia do Utilizador Página 62

Comentários a estes Manuais