
ServSwitch Uno/Duo USB Installation and Use Page 46
command key before a new hotkey command is accepted by the ServSwitch.
HOTKEYs + TAB is an exception and this allows you to 'tab through' the ports by
holding down the hotkeys and repeatedly pressing TAB. HOTKEYs + the cursor
keys is also an exception. You can hold down the hotkeys and repeatedly press the
cursor keys to change the position of the on-screen menu.
The hotkey commands are summarized below (note that the numbers on the
numeric keypad do not form part of a valid hotkey). The hotkeys will only select the
requested channels if you have access rights to the requested channel.
Selecting computers using the hotkeys and the port number is most suitable for
systems with small numbers of computers. For systems with more computers it is
easier to use the on-screen menu for computer selection.
‘HOTKEYs’ and ‘1’ - selects channel 1
‘HOTKEYs’ and ‘2’ - selects channel 2
‘HOTKEYs’ and ‘3’ - selects channel 3
‘HOTKEYs’ and ‘4’ - selects channel 4
‘HOTKEYs’ and ‘5’ - selects channel 5
‘HOTKEYs’ and ‘6’ - selects channel 6
‘HOTKEYs’ and ‘7’ - selects channel 7
‘HOTKEYs’ and ‘8’ - selects channel 8
‘HOTKEYs’ and ‘9’ - selects channel 9 (16 port models only)
‘HOTKEYs’ and ‘1 then 0’ - selects channel 10 (16 port models only)
‘HOTKEYs’ and ‘1 then 1’ - selects channel 11 (16 port models only)
‘HOTKEYs’ and ‘1 then 2’ - selects channel 12 (16 port models only)
‘HOTKEYs’ and ‘1 then 3’ - selects channel 13 (16 port models only)
‘HOTKEYs’ and ‘1 then 4’ - selects channel 14 (16 port models only)
‘HOTKEYs’ and ‘1 then 5’ - selects channel 15 (16 port models only)
‘HOTKEYs’ and ‘1 then 6’ - selects channel 16 (16 port models only)
‘HOTKEYs’ and ‘TAB’ - selects the next available channel
‘HOTKEYs’ and ‘M’ - displays the on-screen menu for selecting computers by name
(this is the recommended way of selecting computers for systems with more than 4
computers)
Comentários a estes Manuais