Black-box COMPACT T1 MT850A Manual do Utilizador Página 473
- Página / 592
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Compact T1 - Release 6.1 13-17
Router (IP) Card
LEDs
LEDs
The following chart describes each LED, and it’s state, of the Router card.
LED State Description
CRD Off Loss of power
Green No current alarms
Red Alarm state active. See alarm log for cause
Red Flashing Self-test or Boot in-process
Yellow Flashing Card is saving data to flash RAM, do not
power down
10/100 Off 10 Mb ethernet
Green 100 Mb ethernet
LNK Off No ethernet link
Green Good ethernet link
COL
Off No current ethernet transmit collisions
Yellow Ethernet collisions have occurred and
have not dropped to minimum level
Yellow Flashing Ethernet collision occurring
TX Off No ethernet transmit activity
Green Ethernet transmit activity
RX Off No current ethernet receive activity
Green Current ethernet receive activity
- Compact T1 1
- Supporting Software Version: 2
- Controller 6.1 2
- IP Router 1.6 2
- CMG Router 2.0 2
- Compliance 3
- Interference Statements 5
- Preface 7
- Safety Information 8
- NOT HANDLE ICS 10
- TABLE OF CONTENTS 11
- 2 Physical Installation 12
- 4 Configuration 13
- 5 CLI Commands 14
- Table of Contents 15
- Table of Contents 16
- 6 T1 Controller Card 22
- 7 FXO Voice Card 23
- 8 FXS Voice Card 23
- 9 ISDN BRI Card 24
- 10 OCU-DP Card 24
- 11 Power Supply 25
- 12 Quad T1 Card 26
- 13 Router (IP) Card 26
- 14 Router (CMG) Card 27
- 15 V.35/V.54 Cards 28
- 16 Maintenance 29
- A SNMP Interface 29
- Glossary 30
- Base Platform 31
- Overview 32
- Features 33
- Dual T1 Controller 33
- Power Supply 33
- Service Cards 34
- IP Router Service card 35
- CMG Router Service card 35
- Local and Remote Management 36
- Technical Specifications 36
- Base Platform 37
- Physical Information 39
- T1 and 10Base-T Ethernet 42
- Physical Installation 43
- Unpacking and Inspection 44
- Installation Environment 44
- Assembly of Unit 45
- Wall Mounting 46
- Physical Installation 47
- In this Chapter 51
- Compliant Installation 52
- Ferrite Beads 53
- Interface Connectors 54
- Chassis Ground Connector 55
- Power Reset 56
- Power Connections 56
- Battery 57
- Return (+) 57
- -48 VDC (-) 57
- External Alarm Connector 58
- 25-Pair Telco Connectors 59
- T1 Connection Ports 62
- 10Base-T Ethernet 62
- Setting up a CLI Connection 64
- System Information 65
- Basic System Setup 66
- Set Up Security 67
- Set Up a DS1/T1 67
- Set Up a DS0/Channel 68
- Set Up an Analog Port 68
- Set Up the Router Card 69
- Set Up a ISDN BRI Service 70
- Set Up the OCU-DP Card 71
- Set Up a V.35 Port 72
- Configuration 73
- Quick Configuration Reload 74
- from the menu bar 75
- Equipment Required 78
- Application Overview 78
- Operation 78
- Configure the Router 79
- Setup the Profile for Site A 80
- Setup the Profile for Site B 80
- Setup the Profile for Site C 81
- Remote Site A Configuration 81
- Remote Site B Configuration 82
- Remote Site C Configuration 83
- Command Line Interface Help 86
- CLI Commands 100
- Example: set ntp timezone -5 169
- [minute-offset] 212
- 322
- Display Descriptions 340
- T1 Controller Card 371
- Management 375
- Network T1 Interface 375
- Service Interfaces Supported 376
- Network Standards 376
- Clocking 376
- Testing and Diagnostics 377
- Power Consumption 377
- Regulatory Approvals 377
- Physical 377
- Configuration 378
- DIP Switch Settings 379
- 0 (Off) 1 (On) 380
- DS0 Management (IP over DS0) 381
- TR-08 Mode 1 382
- FXO Voice Card 385
- FXO Transmission Performance 388
- FXO Signaling Performance 388
- Card Configuration 390
- Conversions 393
- FXS Voice Card 395
- FXS Signaling Performance 399
- ISDN BRI Card 405
- Testing & Diagnostics 409
- Product Supports 409
- Connector Pinouts 413
- SLOT 1 on J1 or SLOT 4 on J2 414
- SLOT 2 on J1 or SLOT 5 on J2 414
- SLOT 3 on J1 or SLOT 6 on J2 415
- OCU-DP Card 417
- Customer Premise Application 419
- SS7 Backhaul Application 420
- Basic Setup 425
- Jumper Settings 427
- Line Rates/Line Lengths 429
- 25-Pair Telco Connector 431
- Ringing Generators 436
- Input Power 437
- 115 VAC LEDs 438
- Ringer Waveform Options 439
- Standard Waveform 440
- Square Waveform 441
- Replacing a Power Supply 443
- Quad T1 Card 445
- T1 Interface 448
- Network Interface 448
- P2 and P3 Jumpers 451
- Front Back 451
- RJ-48 Connector 454
- Configuration Restrictions 456
- Router (IP) Card 457
- Controller Software Required 459
- Advanced Capabilities 461
- Frame Relay 461
- Filtering 461
- Security 461
- Router (CMG) Card 475
- Routing and Policy Management 479
- Router Performance 480
- TDM-Side Signaling 480
- Connector Pinout 494
- BroadSoft™ 495
- Compact T1 Settings 496
- V.35/V.54 Cards 499
- Accessories 503
- Maintenance 509
- Software Upgrade 510
- Maintenance 511
- Using HyperTerminal 514
- Using Procomm 514
- Save Controller Configuration 515
- Load Controller Configuration 516
- Replace Controller Card 517
- Hot Swap Service Card 517
- APPENDIX 519
- SNMP Basics 520
- Enterprise MIB Support 521
- Router Enterprise MIB Support 522
- SNMP Interface 523
- Public MIB Support 524
- Router Public MIB Support 525
- SNMP Trap Reports 526
- Enterprise Traps 527
- SNMP Interface 528
- Test Alarm 530
- Identify Alarm 530
- Compact T1 - Release 6.1 B-3 531
- Clear Alarm 532
- Example: log 533
- Status and Performance 534
- Loopbacks Overview 535
- DS1 Loopbacks 536
- DS1 Payload Loop 537
- Receiving DS1 CSU Loop 538
- Compact T1 - Release 6.1 B-11 539
- DS1 Equipment Loop 540
- Compact T1 - Release 6.1 B-13 541
- View Status of Loopback 541
- V.35 Loopbacks 542
- Compact T1 - Release 6.1 B-15 543
- Disable Line Loopback 543
- V.35 Equipment Loop 544
- Compact T1 - Release 6.1 B-17 545
- Disable Equipment Loopback 545
- V.35/V.54 Loop 546
- V.54 Loop 547
- B-20 Compact T1 - Release 6.1 548
- V.54 Equipment Loopback 549
- B-22 Compact T1 - Release 6.1 550
- Disable V.54 Equipment Loopup 550
- OCU-DP Loopbacks 551
- Non-Latching Loopdetect 552
- CSU Manual Loopback 553
- Manual OCU Loopback 554
- Compact T1 - Release 6.1 B-27 555
- Verification 556
- Statistics 556
- System Reports 557
- B-30 Compact T1 - Release 6.1 558
- GLOSSARY 559
- Glossary 561
Manuais e produtos relacionados com Hardware Black-box COMPACT T1 MT850A
Hardware Black-box GEH-6510 Manual do Utilizador
(92 páginas)
(92 páginas)
Hardware Black-box IC136C Manual do Utilizador
(23 páginas)
(23 páginas)
Hardware Black-box RM 415A Manual do Utilizador
(1 páginas)
(1 páginas)
Hardware Black-box EVNSL17A Manual do Utilizador
(1 páginas)
(1 páginas)
Hardware Black-box 21834 Manual do Utilizador
(2 páginas)
(2 páginas)
Hardware Black-box LRU4240 Manual do Utilizador
(218 páginas)
(218 páginas)
Hardware Black-box CAT5E Manual do Utilizador
(2 páginas)
(2 páginas)
Hardware Black-box CAT6a Manual do Utilizador
(2 páginas)
(2 páginas)
Hardware Black-box Modem Manual do Utilizador
(3 páginas)
(3 páginas)
Hardware Black-box COMPACT T1 Manual do Utilizador
(42 páginas)
(42 páginas)
Hardware Black-box CAT6 Manual do Utilizador
(3 páginas)
(3 páginas)
Hardware Black-box 25357 Manual do Utilizador
(2 páginas)
(2 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.060 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais