Black Box V5.1 Guia de Resolução de Problemas descarregar pdf (Página 18)

Euro MotoElectrics, 25958 Genesee Trail Road PMB 321 Golden, Colorado USA 80401 EDL-IGN Page 18 of 43

www.EuroMotoElectrics.com info@euromotoelectrics.com Tel: 1-303-526-0901

EnDuraSpark Electronic Ignition

Installation & Troubleshooting v5.1

1. The green/yellow stripe wire that was connected to the original ignition control unit

connects to one side of the Relay coil terminal.

2. Connect the Red wire from the EnduraSpark Black Box to the same terminal

3. Connect the other Relay Coil terminal to a good frame ground terminal

4. Connect the original green “switched” wire of the ignition coil to one side of the “switch”

terminals of the relay

5. Connect the other “switch” terminal of the relay and connect to the left ignition coil.

6. Continue with connecting the Black trigger wire from the Black Box to the right coil, and

the Brown wire from Black Box to ground.

7. Connect the thin black tachometer wire to the same terminal of the trigger wire. Verify all

connections.

With the key switch “on” and the kill switch in the on or run position, there will now be power to

the EnduraSpark Black Box and the relay will be energized.

By switching the kill switch to off, the power is cut to the relay and Black Box, as well as killing

power to the ignition coils.

Red lead to black box

Original ignition

control wiring

Ground connection

Switched power

Left coil

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 42 43

Sem comentários

Black Box V5.1 Guia de Resolução de Problemas Página 18