Black Box V5.1 Guia de Resolução de Problemas descarregar pdf (Página 39)

Euro MotoElectrics, 25958 Genesee Trail Road PMB 321 Golden, Colorado USA 80401 EDL-IGN Page 39 of 43

www.EuroMotoElectrics.com info@euromotoelectrics.com Tel: 1-303-526-0901

EnDuraSpark Electronic Ignition

Installation & Troubleshooting v5.1

If the entire bike’s electrical system goes dead intermittently (i.e. no instrument lights and no

brake lights) then the problem is probably:

 A bad battery connection, either positive or negative cable,

 A corroded connector on the battery end of the battery cables,

 A bad battery,

 A loose connection of the battery ground bolt on the transmission, or

 Corroded red wires on the spade terminals of the starter relay.

On these older bikes there are a couple of places that have been troublesome. The crimp

connections on the jumper wire between the two ignition coils can loosen, causing intermittent

ignition problems. The right handlebar engine kill switch may be severely corroded, especially on

a bike left outdoors or washed with a pressure washer.

Finally, if everything else checks out, the Hall element on the EnDuraSpark trigger may be

failing. This is usually caused by lifting a spark plug cap off a spark plug on a running engine.

1 2 ... 34 35 36 37 38 39 40 41 42 43

Sem comentários

Black Box V5.1 Guia de Resolução de Problemas Página 39