Black Box V5.1 Guia de Resolução de Problemas descarregar pdf (Página 37)

Euro MotoElectrics, 25958 Genesee Trail Road PMB 321 Golden, Colorado USA 80401 EDL-IGN Page 37 of 43

www.EuroMotoElectrics.com info@euromotoelectrics.com Tel: 1-303-526-0901

EnDuraSpark Electronic Ignition

Installation & Troubleshooting v5.1

Troubleshooting - No Spark (continued)

Check Black Box & Trigger

Turn over the engine with the starter. The LED on the

trigger should turn on and off in the timing wheel

range shown in red:

 If the LED turns on and off correctly and there

is still no spark, open the black box and place

all the DIP switches in the OFF position. With

an external spark plug connected and

grounded to the engine, the plug should

continuously fire when the ignition is turned

on. If not, the black box is defective.

If the plug does fire the cables between the

sensor and black box, or their connector, is

defective.

 If the LED never turns off, loosen the set

screws on the timing wheel and slide it in or out slightly on the hub to better align

the Hall sensor with the magnets in the timing wheel. If the LED cannot be made

to turn on and off the trigger unit is defective.

 If the LED never comes on, double check

there is 12 volts on the coil terminal with

the red wire going to the black box. If

not, there is a loose connection there or a

bad cable on the black box.

If the 12V is there, unplug the connector

between the black box and the trigger.

Stick paper clips in the socket as shown

and check for 4.7 – 5V (the center

connection is ground). If not, the black

box is defective.

If there is 5V, the cable on the trigger or the trigger itself is defective.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43

Sem comentários

Black Box V5.1 Guia de Resolução de Problemas Página 37