Black Box IC108A Guia do Utilizador descarregar pdf (Página 5)

Advant

Smart Device (HART

) Interface User’s Guide

3BUR 001 085R0001 REV A 1-1

Chapter 1 Introduction

1.1 General Information

This instruction book is a guide for configuring the Advant

Smart Device (HART

) Interface

which allows you to connect smart devices to an Advant Controller. Information on planning,

organizing, and entering data base parameters from the Structure Builder are explained in detail.

Also described are other data base configuration entries necessary to provide support for the

interface.

This book is not intended to be the sole source of instruction for Advant Smart Device (HART)

Interface software. Those people involved in system engineering should attend the applicable

system engineering courses offered by ABB.

1.2 Equipment Requirements

The Advant Smart Device (HART) Interface is part of the Advant Controller 410 or Advant

Controller 460 subsystem and is used to view and manipulate variables from attached smart

devices.

An Advant Controller 410 can be equipped with one or two MultiVendor Interface (MVI)

modules which have two RS-232 serial ports each, for a total of 4 ports. Communication is

provided by connections between these modules and the SHIMs (Small HART Interface

Module) that connect to smart devices.

An Advant Controller 460 can have 3 CPUs with each CPU having one to four MVI modules

with two RS-232 serial ports each, for a total of 8 ports. Communication is provided by

connections between these modules and the SHIMs that connect to smart devices.

Chapter 2, Installation, of this manual provides information about the types of connections

needed between the smart devices and the system.

1 2 3 4 5 6 7 8 9 10 ... 117 118

Sem comentários

Black Box IC108A Guia do Utilizador Página 5