Black Box IC108A Guia do Utilizador descarregar pdf (Página 75)

Advant

Smart Device (HART

) Interface User’s Guide

Section 3.3.5 Configuration of Smart Device (PLC) Parameters

3BUR 001 085R0001 REV A 3-21

PROTOCOL

Enter the protocol type depending on the MVI submodule installed and protocol required.

The possible entries are:

GENERIC for CI532V05 MVI

TERMCHAR for CI532V05 MVI

ALLENBRADLEY for CI532V04 MVI

MODBUSB for CI532V02 MVI <- used for SHIMs

NOTE

Each type of MVI submodule has a special PROM set to run the various

protocols. The protocol configured above must be set to match the submodule’s

characteristics.

PORT NAME

Enter the Templet Name for the MVI_PORT object that this PLC_PORT will be connected to.

Refer to Figure 3-7 for an example of the templet name of an MVI_PORT.

NOTE

Do not configure multiple PLC_PORT objects associated with the same

MVI_PORT name.

BACKUP PORT NAME

Enter the Templet Name for the MVI_PORT object that is the back-up port for redundant

communications that this PLC_PORT will be connected to. If this field is left blank, then there

is no back-up port defined. Refer to Figure 3-7 for an example of the templet name of an

MVI_PORT.

Leave blank for SHIMs.

INTERFACE ADDR

This is used for data highways, and is the address of the interface between the serial port and the

data highway. Smart devices do not have interface address modules defined, so this value should

be left at the default value (1).

Default = 1.

Enter 1 for SHIMs.

BACKUP INT ADDR

This is the back-up interface board address of the smart device that is used to communicate with

the system. Some smart devices do not need back-up interface address modules defined, so this

value should be zero(0).

Default = 0.

Leave blank for SHIMs.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 117 118

Sem comentários

Black Box IC108A Guia do Utilizador Página 75